Using The Wall-Mounting Brackets - ABB HVC-R 100/150 V2 Installation Manual

5.13.1.

Using the wall-mounting brackets

Make sure that the wall, onto which the Dual Depot Charge Box is to be
installed, will support the weight of the device.
The Dual Depot Charge Box can be easily mounted by using the wall-mounting brackets, see
Wall-mounting brackets for Dual Depot Charge Box safe wall fixing on Page 21.
Attaching wall-mounting brackets to the Dual Depot Charge Box
1. Determine whether the wall-mounting brackets (D) should be mounted horizontally or
vertically, see also section Wall mounting on Page 46.
2. Put the wall-mounting brackets (D) (4x) against the back side of the Dual Depot Charge
Box.
3. Insert M6 bolts (A), washers (B) and spring washers (C) into the holes of the back side
and into the wall-mounting brackets (D) (4x).
4. Tighten the bolts with a tightening torque of 10 – 15 Nm.
5. Drill 4 holes (G) in the wall with a 12 mm drill following the diagram in section Wall
mounting on Page 46.
6. Place the 12x60 wall plugs (H) inside the holes (G).
7. Carefully place the Dual Depot Charge Box against the wall.
8. Make sure that the Dual Depot Charge Box is aligned with the drilled holes (G) in the
wall.
9. Insert the M8 wall screw (E) fitted with the washers (F) into the holes of the wall-
mounting brackets (D) (4x).
10. Tighten the wall screws with a tightening torque of 10 – 15 Nm.
Document: v0.1 / Document No.: TBA | Date: XX-08-2021
HVC-R 100/150 V2 E-Bus Charger Installation Guide
NOTICE
Page 89 of 133