Table of Contents
Advertisement
5.14.12.
Connecting the communication Ethernet cable (output)
Information in this chapter refers to the communication cables connecting the Dual Depot
Charge Box to the next Dual Depot Charge Box.
1. Loosen and remove the cable gland's (#16) nut for the communication Ethernet
cable.
2. Insert the communication cable into the cable gland (#16) and tighten the cable
gland's nut to secure the cable(s).
Location of terminal X12 and instructions on the connection.
3. Route the Ethernet cable to the terminal X12 (refer to the picture above for the
preferred cable route). Do not make the cable routing too tight, or too loose.
4. Plug the cable's RJ45 connector into the terminal X12's socket.
5. Tighten the nut of the gland to secure the Ethernet cable.
Document: v0.1 / Document No.: TBA | Date: XX-08-2021
HVC-R 100/150 V2 E-Bus Charger Installation Guide
Page 105 of 133
Advertisement
Table of Contents
