Connecting The Pe Or Lighting Protection Wire Onto The Pedestal - ABB HVC-R 100/150 V2 Installation Manual

5.14.6.

Connecting the PE or lighting protection wire onto the pedestal

Prerequisites:

Tools: wire cutter, wire stripper pliers, cable lugs (2x), spanner (size 13), torque wrench
(size 13).
Instructions on connecting PE or lightning protection wire to the pedestal.
In case the Dual Depot Charge Box is mounted on a pedestal, it is crucial that the pedestal is
connected to the Dual Depot Charge Box's PE or lightning protection system with a wire.
For safety, it is recommended to make a loop on the PE wire so it is
longer than the phase wires. This loop ensures that the PE wire is not the
first wire that is disconnected if the Dual Depot Charge Box is moved by
a collision.
Document: v0.1 / Document No.: TBA | Date: XX-08-2021
Instructions on preparing the PE wires.
HVC-R 100/150 V2 E-Bus Charger Installation Guide
NOTICE
Page 96 of 133