2. Mind the cables connected to the fans. They must be unplugged before moving the
cover plate.
3. Put the protection plate (A), the screws and the washers (B) in a safe location as it will
be installed back later on.
It is not allowed to remove the connector plates (marked in the picture
below), nor to loosen their mountings.
Document: v0.1 / Document No.: TBA | Date: XX-08-2021
Removing the protection cover
WARNING
Location of the connector plates
HVC-R 100/150 V2 E-Bus Charger Installation Guide
Page 93 of 133