7.4
Connect the DC power cable in the power cabinet
Preliminary requirements
Procedure
1. Prepare the DC+ cables:
a. Cut the DC+ cables (A) to
b. Strip the insulation from the
c. Attach the cable lug to the
2. Attach the DC+ cables to the
DC+ terminal block (C).
Use the fasteners (B).
1. Prepare the DC- cables:
a. Cut the DC- cables (D) to
b. Strip the insulation from the
c. Attach the cable lug to the
2. Attach the DC- cables to the
DC- terminal block (F).
Use the fasteners (E).
6AGA000032-0115-EN | 004
•
Wire stripper pliers
•
Wire cutter
•
Torque wrench
•
Cable lug
•
Fasteners M11
make sure that the length
is sufficient for connection
at the DC+ terminal block (C).
end of the cables. Make sure
that the stripped length is
compatible with the cable
lug specification.
end of the wires.
make sure that the length
is sufficient for connection
at the DC- terminal block (F).
end of the cables. Make sure
that the stripped length is
compatible with the cable
lug specification.
end of the wires.
Electrical installation of the power cabinet
•
C
B
A
F
E
D
47