Ethernet Port Boot Order And Device Naming - Oracle Sun Server X4-4 Service Manual

Assign Serial Port Output Using the Web Interface
1. Log in to the service processor Oracle ILOM web interface.
To log in, open a web browser and direct it using the IP address of the server SP. Log in as root
or a user with administrator privileges. See
The Summary screen appears.
2. In the ILOM web interface, select ILOM Administration --> Connectivity from the
navigation menu on the left side of the screen.
3. Select the Serial Port tab.
The Serial Port Settings page appears.
Note -
4.
In the Serial Port Settings page, select Host Server as the serial port owner.
5.
Click Save for the changes to take effect.
6. Connect a serial host to the server.

Ethernet Port Boot Order and Device Naming

This section contains information about the boot order and device naming for the four
10 GigabitEthernet ports on the back panel of the server (see
Locations" on page
two top ports are NET2 and NET 3, as shown in the following illustration.
60 Sun Server X4-4 Service Manual • October 2015
The serial port sharing setting by default is Service Processor.
58). From left to right, the two bottom ports are NET 0 and NET 1; the
Oracle X4 Series Servers Administration Guide
"Back Panel Connector
.