Piper COMANCHE PA-24-180 Service Manual page 97

PIPER COMANCHE SERVICE MANUAL
TABLE III-I. INSPECTION REPORT (cont.)
- Note -
All inspections or operations must be performed at each inspection interval
as indicated by a circle (O).
Nature of Inspection
E. FUSELAGE AND EMPENNAGE GROUP (CONT.)
14. Inspect fin front spar to fuselage attachment, per latest revision
of Piper Service Letter No. 751 and AD No. 75-12-06..................................
15. Inspect fin, rudder and stabilator surfaces for damages .................................
16. Inspect rudder and rudder tab hinges, horns and attachments
for security, damage and operation ................................................................
17. Inspect rudder trim mechanism operation ......................................................
18. Inspect all control cables and trim cables for correct cable tension,
and turnbuckles, guides, and pulleys
for damage, operation and safeties (See Note 20)..........................................
19. Replace rudder hinge bolts .............................................................................
20. Inspect rotating beacon for wear, etc..............................................................
21. Lubricate per lubrication chart in Section ..................................................
22. Inspect security and condition of Autopilot bridle cables and clamps...........
23. Reinstall inspection panels and plates ............................................................
Inspection Time (Hrs)
50
100 500 1000
O O
O
O
O
O
O
O
O
O O
O
O O
O
O
O
O
O O
o
O
O
O
O O
O
O O
o
0
0
E WING GROUP
1 . Remove inspection plates and fairings ...........................................................
2. Inspect wing, aileron and flap surfaces for damage and loose
rivets, and condition of wing tips ...................................................................
3. Inspect condition of walkway .......................................................................
4. Inspect aileron attachments and hinges for damage, looseness
and operation..................................................................................................
5. Inspect aileron balance weight and arm for security and condition ...............
6. Replace outboard aileron hinges with
Aileron Outboard Hinge Bracket Kit No. 760-914........................................
7. Inspect aileron cables for correct tension, pulleys, bellcranks and
control rods for corrosion, damage and operation (See Note 20) ..................
8. Inspect flap attachments and hinges, or tracks and rollers for
damage, looseness and operation. Clean tracks and rollers ...........................
9. Inspect flap cables, pulleys, step lock, bellcranks and rods for
corrosion, damage and operation (See Note 20) ............................................
10. Replace pins and/or bolts used with aileron hinges and flap
hinges or tracks...............................................................................................
11. Lubricate per lubrication chart in Section II ..................................................
12. Inspect wing attachment bolts and brackets (See Note 18)............................
O
0 0
O
O
O
O
o
O
O
O
O
O
O O
0
Revised: 8/15/98
INSPECTION
1E1