Piper COMANCHE PA-24-180 Service Manual page 96

PIPER COMANCHE SERVICE MANUAL
TABLE III-I. INSPECTION REPORT (cont.)
- Note -
All inspections or operations must be performed at each inspection interval
as indicated by a circle (0).
Nature of Inspection
Inspection Time (Hrs)
D. CABIN GROUP (CONT.)
7. Inspect control wheels, column, pulleys and cables.......................................
8. Check landing, navigation, cabin and instrument lights ................................
9. Inspect instruments, lines and attachments ....................................................
10. Inspect instruments, central air filter lines and replace filter. ........................
11. Inspect condition of vacuum operated instruments and operation
of electric turn and bank (Overhaul or replace as required)...........................
12. Replace vacuum regulator filter .....................................................................
13. Replace filters, if equipped, in gyro horizon and directional gyro.................
14. Inspect altimeter (Calibrate altimeter system in accordance
with FAR 91.170, if appropriate) ..............
.....................................................
15. Inspect operation of fuel selector valve (See Note 14) ..................................
16. Inspect oxygen outlets for defects and corrosion ...........................................
17. Inspect oxygen system operation and components ........................................
50 100 500 1000
O
O O
O O
O
O O
O
O
O O
O O
O
O
O O
O
O
O
O O
O
O O
O O
O
O O O
E. FUSELAGE AND EMPENNAGE GROUP
1. Remove inspection panels and plates (See Note 22)......................................
2. Check fluid in brake reservoir (Fill as required) ............................................
3. Inspect battery, box and cables.
(* at least every 30 days)
Clean and flush box as required and fill battery per Section IX ....................
4. Inspect electronic installations ...........
........................................
5. Inspect bulkheads and stringers for damage ..................................................
6. Inspect loop and loop mount, antenna mount and electric wiring .................
7. Inspect E.L.T. installation and condition of battery and antenna
(See latest revision Piper Service Letter No. 820) .........................................
8. Remove, drain, and clean fuel filter bowl and screen
(* Drain and clean at least every 90 days) .....................................................
9. Inspect fuel lines, valves and gauges for damage and operation
(See Notes 7 and 13) ......................................................................................
10. Inspect security of all lines.............................................................................
11. Inspect stabilator and stabilator trim tabs for security ofmounting,
free play of components and ease of operation (See Sections IV and V) ......
12. Inspect stabilator bearings, bungee, and stabilator trim horns control
rod and trim mechanism for security of installation, damage and
operation (Refer to latest Piper Service Bulletin No. 464) ............................
3. Inspect stabilator tip balance weight arm for cracks ......................................
SECTION
0
O*
O*
0
O O
O O O
O
0 0
O
O O
O O
O
O O O
O O
O
O O
O
O O
O
O
O O
O
O O
O
O O
O O
O
O
Revised: 8/15/98
1D24