Piper COMANCHE PA-24-180 Service Manual page 341

7
a.
Remove the spinner (10) by removing the screws (11) that secure it to the spinner bulkhead (5)
b.
Place a dnp pan under the propeller to catch oil spllage.
c.
Cut the saferv wire around the propeller mounting bolts (8) and remove the bolts from rne engine
crankshaft flange.
d.
Pull the propeller from the engine crankshaft.
e.
Remove the propeller '0" nng (6) from the propeller hub bore.
f
The spinner bulkhead (5) may be removed from the starer ring gear (4) bv removing nuts. washers
and bolts
POWER PLANT
ISSUED: 8/18/72
PIPER COMANCHE SERVICE MANUAL
4 2 1
10
2
-3
5
6
B
B
1 BOLT
2 PLAIN WASHER
3 SELF-LOCKIG NUT
4 STARTER RING GEAR SUPPORT
SPINNER ADAPTOR RING
6 "O" RING SEAL
7 PROPELLER
HUB MOUNTING BOLT
9 WASHER
10 SPINNER
It TRUSS HEAD SCREW
12 FIBER WASHER
0
..
12
FIGURE 7A-1. PROPELLER INSTALLATION (MCCAULEY) PA.24-25
7A-12. Removal Of Propeller. (McCauley) (PA-24-250) (Refer to Figure 7A-1 )
NOTE
In some manner identfvy the position of each pa
in relation to the
other to facilitate insrllaton.
2 C7