Piper COMANCHE PA-24-180 Service Manual page 243

6-61. Removal Of Landing Gear Warning Switch.
c. On airplanes with Serial Nos. 24-4783, 24-4804 and up, remove the landing gear warning micro
switch, located in the throttle quadrant, by the following procedure:
I.
Remove the left trim cover from the throttle quadrant by removing attaching screws.
2. Remove switch mounting nuts, washers and screws.
3.
Disconnect the electrical leads at the micro switch.
6-62. Installation Of Landing Gear Warning Switch.
a. On airplanes with Serial Nos. 24-1 to 24-4782 inclusive, 24-4784 to 24-4803 inclusive and
PA-24-400. install micro switch by the following procedure:
1. Connect electrical leads to micro switch.
2. Install actuator and micro switch on mounting bracket and secure with screws, lockwashers
and nuts.
3. Adjust switch per Paragraph 6-63.
b. On airplanes with Serial Nos. 24-4783, 24-4804 and up, install micro switch by the following
procedure:
I. Connect electrical leads to micro switch.
1. Connect electrical leads to micro switch.
PIPER COMANCHE SERVICE MANUAL
ISSUED: 8/18/72
LANDING GEAR AND BRAKE SYSTEM
1K3