Piper COMANCHE PA-24-180 Service Manual page 110

AU1
1
2
1' NUT
2 WASHER
3 SPACER
4 SPACER WASHER
B BOLT
S WING FITTING
7 FLAP FTTNG
8 BOLT
9 TRACK
10 ROLLER. NYLON
f. In the right wing, by entering through the wheel well, draw the flap return step lock cable
and connect. Engage the step lock. In the left wing connect the flap return spring.
g. Check flap rigging and adjustments. (Refer to Rigging Of Flap, Section V.)
h. Install acces
plates and wheel well splash pn.
NOTE
When installing flap rollers, position spacer washers to allow no
side binding and ascertain that the roller bushings will roll free.
PIPER COMANCHE SERVICE MANUAL
1 NUT
2 WASHER
3 SPACER
4 SPACER WASHER
6 BOLT
e WING FrFTNG
7 FLAP FITTNG
1
7
FIGURE 4-3. FLAP ROLLER INSTALLATION
(ELECTRICALLY OPERATED)
FIGURE 4.4. AILERON BEARING
INSTALLATION
4-26. Installation Of Flop. (PA.24-400)
a. Ascertain that the flap control rod is installed on the flap.
b. Position the flap in place, lubricate the flap rollers and tracks(Refer to Lubrication Chart,
Section 11) and install the lower roller assemblies. (Refer to figure 4-3.)
c. Swing the flap rearward and install the remaining assemblies. Move the flap through its
full travel to ascertain that there is no binding.
d. The right flao, insert the step lock cable through the leading edge.
e. Connect the flap control rod to the bellcrank.
f. Enter through the right wheel well and connect the step lock return spring. Engage the
step lock.
g. Check flap rigging and adjustments. (Refer to Rigging Of Flap, Section V.)
h. Install access plates and wheel well splash pan.
4-27. Installation Of Aileron.
a. Position the aileron, lubricate (Refer to Lubrication Chart. Section II) and install the in-
board hinge bolt. (Refer to figure 4-4.) Install the outboard bolt. Place the spacer washers to
allow for best alignment of hinges. Move the aileron through its full travel to ascertain that there
is no binding.
STRUCTURE
ISSUED: 8/18/72
1E14