Piper COMANCHE PA-24-180 Service Manual page 344

PIPER COMANCHE SERVICE MANUAL
7 6
3 WASHER
SPINNER ADAPTOR RING
6 ENGINE STARTER GEAR
6 BOLT
7 WASHER
/
HUB MOUNTING BOLT
10 "0" RING SEAL
11 PROPELLER MOUNTING SHIM
FIGURE 7A-3. PROPELLER INSTALLATION (HARTZELL) PA-24-250
7A-15 Removal Of Propeller. (HarzeU) (PA-24-Z50) (Refer to Figure
7A3
)
NOTE
In some manner identify the position of each par in relation to the
ocner to facilitate instralation.
a.
Ascertain that the master switch and magneto switches are in the OFF position.
b Remove the spinner (I ) by removing the screws that secure it to the spinner bulkhead (4)
c. Place a drip pan under the propeller to catch oil spillage.
d. Cut the safer- wire around the propeller mounting bolts (8) and remove them from tne ernine
crankshart rlange
e. Pull the propeller from the engine cranKshatr
f. Remove the proeller '0" nng (10) and shum (11) from the engine flange
g. The spinner bulkhead (4) may be removed from the scarer ring gear (8) by removing nuts washers
and bolts
POWER PLANT
ISSUED: 8/18/72
2 C10