Piper COMANCHE PA-24-180 Service Manual page 353

PIPER COMANCHE SERVICE MANUAL
Connect bonding straps to engine and engine mount
i
Connect throttle and mixture controls and adjust per paragraphs 7A-52 or 7A-61
k Connect carburetor heat control and adjust per paragraph 7A-52.
I Connect goxernor control cable to governor and secure with clamps
m
Install carburetor inlet fuel line and fuel pressure line
n Install oil cooler lines
o
Connect fuel lines to engine driven fuel pumps
p
Install spark plug leads and clamp.
q Connect engine breather hose to engine accessory housing
r Connect
s. Connect
I Connect
u. Connect
.
Connect
W. Connect
x Connect
y Connect
7 Connect
oil temperature wire to accessory housing.
tachometer cable to fitting on engine accessory housing.
magneto "P" leads to magnetos. and safety
manifold pressure line to No 6 cylinder
primer line
cylinder head temperature wire to No 5 cylinder
oil pressure line to engine accessory housing
air oil separator drain hose to engi,,.. iccessoryy housing.
vacuum hose to xacuum pump
aa
Install air duct on muffler shroud and right rear baffle
ab.
Install fuel pump blast tube
ac Install propeller (Refer to paragraph 7A-14 or 7A-17 )
ad
Install the proper grade and amount of engine oil
NOTE
Refer to latest Lcoming Ser ice Instruction No 1241
ae
af
for fuel le
Install engine cowling (Refer to paragraph 7A-7 )
Connect battery ground cable. turn fuel selector valve on and turn on auxiliary fuel pump Check
aks
2C19
REVISEI