Table of Contents
Advertisement
3. 3. 4. Test Tube Rack Installation
CAUTION Cutting injuries from sharp edges. Be cautious while handling platforms
and other accessories.
Each test tube rack consists of two mounting brackets (wire frame or sheet
metal) with a locking knob and two finger screws per test tube carrier for
mounting it on the platform. Each test tube rack assembly comes pre-
assembled with a test tube rack and foam insert(s). Always use the screws
supplied with the rack.
Figure 83: Test Tube Rack Assembly with Wire-Frame Mounting Brackets
Figure 84: Test Tube Rack Assembly with Sheet Metal Mounting Bracket
Install as follows:
1.
Install the mounting brackets on the platform using the finger screws.
Tighten the finger screws until hand tight.
2.
Insert the test tube rack into the mounting brackets.
3.
Set the required angle by using the locking knobs. Tighten the locking
knobs until hand tight.
Accessories
98 / 143
➀ Test tube rack
➁ Foam inserts
➂ Finger screws
➃ Mounting bracket
➄ Locking knob
➀ Test tube rack
➁ Foam inserts
➂ Locking knob
➃ Mounting bracket
Advertisement
Table of Contents
