Thermo Scientific Solaris Series Instruction Manual page 76

Graphical User Interface
Controls
The Controls screen provides options for pre-setting the default operating
parameters you wish the unit to start with:
Speed Setpoint: You can pre-set the speed setpoint to a value between
15 and 525 rpm. Roll the dials of the wheel picker to pre-set speed and tap
Save. Detailed instructions for using the Speed Setpoint screens appear in
the section "Set Speed" on page 62 in chapter 3. 2. 1.
Time Mode: You can run the shaker in Continuous or Timed mode. In
Continuous mode, you stop the shaker manually at your discretion. In timed
mode, the drive of the shaker stops automatically when the timer expires. For
timed mode, you can pre-set a default runtime and choose whether the GUI
should display elapsed time or remaining time while the shaker is running.
Detailed instructions for using the Time Mode screen appear in the section
"Set Runtime" on page 64 in chapter 3. 2. 1.
Temp Setpoint (temperature-controlled models only): This option lets you
set a default temperature you wish the shaker to display at startup. Detailed
instructions for using the Temp Setpoint screen appear in the section "Set
Temperature" on page 65 in chapter 3. 2. 1.
Auto Restart: This feature restarts the unit after a power outage that has
occurred during a normal start/stop run, the execution of a program, or a
temperature calibration run. If the Auto Restart is set to No, the unit will not
restart after a power outage.
Display
The display settings allows you to change various display options.
Brightness: To adjust the brightness level of the display use the slide control
or the +/– buttons.
Figure 47: Adjust Screen Brightness
75 / 143