Vessel
1.
Carefully place the desired vessel in the clamp by
first pulling the clamp spring far enough apart to
enable the vessel base to be positioned inside the
clamp. Gently slide the vessel into its proper position,
securing it to the wider bottom of the clamp. The
spring will hold the neck of the vessel securely in
place.
2.
Make sure all vessels are securely clamped before
powering on the unit.
Wherever possible, the vessel should be sealed with a stopper to prevent
substances from being thrown out during the mixing action.
3. 3. 3. Square Clamp Installation
CAUTION Biological harm due to broken or leaking vessels. Improperly installed
accessories can lead to spilled samples. Make sure that accessories are installed
properly by using the correct tools and screws. The installation requires a
screwdriver (PH2) with a shaft length of 150 mm / 6 in. (Article Number 75004131).
Make sure that accessories fit reasonably on the platform. Always use a vessel
with an accessory of the proper size. Vessels must be intact and installed properly.
CAUTION Cutting injuries from sharp edges. Be cautious while handling platforms
and other accessories.
Accessories
96 / 143