Thermo Scientific Solaris Series Instruction Manual page 48

Mains Connection
The shaker requires a power source that meets its specifications. Power
supply cables are supplied.
Art. No. Shaker
SK2000 Solaris 2000
SK4000 Solaris 4000
SK2001 Solaris 2000 I
SK4001 Solaris 4000 I
SK2002 Solaris 2000 R
SK4002 Solaris 4000 R
Figure 7: Power supply specifications for shakers
WARNING Damage from inappropriate mains supply or power supply plug. Make
sure that the shaker is plugged only into sockets that are properly grounded
according to valid electrical safety standards. Do not operate the shaker with a
damaged or an inadequately rated power supply cable.
The mains plug must be freely accessible at all times.
To eliminate the hazard of electrical shock, make sure the surface around
the shaker is dry. In the event of accidental spilling or splashing of liquids,
disconnect the shaker from the power source, clean up the spilled liquids
and eliminate any health or biological hazard before continuing.
Disconnect the shaker from the power source while it is not in use.
Fuse
The fuse can be reset when it has tripped due to an overcurrent condition.
The shaker will not be operative until you push the fuse back to its proper
position.
Ethernet
The shaker has an RJ45 Ethernet port, which can be used to connect to
a Local Area Network (LAN). Use only equipment conforming to the IEC
60950-1 standard with the RJ45 Ethernet port. The RJ45 Ethernet port is
prepared for future use when an appropriate update of the software will be
available.
Access Ports
Temperature-contolled shaker models have two lateral orifices referred to
as access ports. These access ports are usually sealed with caps. You can
remove the cap and introduce additional instrumentation, such as an extra
temperature sensor, or feed through cables or tubing, such as the tubes of
the Gassing Manifold.
Product Overview
Specification
100–240 V ±10 %, 50 / 60 Hz
100–240 V ±10 %, 50 / 60 Hz
100–120, 200–240 V ±10 %, 50 / 60 Hz
100–120, 200–240 V ±10 %, 50 / 60 Hz
100–240 V ±10 %, 50 / 60 Hz
100–240 V ±10 %, 50 / 60 Hz
47 / 143