Thermo Scientific Solaris Series Instruction Manual page 106

Prepare Vertical Installation
Figure 91 shows the separatory funnel clamp assembly
stand accessory
B
Figure 91: Separatory Funnel Clamp (right) with Vertical Stand Accessory (left)
1. Fit the separatory funnel clamp to the long end of the vertical mount, as
shown in ➀ and ➁ of
2. Align as follows with the four funnel clamp mounting bores (➁ in
91) of the vertical stand:
a. Use the standard vertical mounting bores (➂ in
with the funnel tap facing downwards.
b. Use the upside down vertical mounting bores (➃ in
install with the funnel tap at facing upwards.
c. Secure the separatory funnel clamp to the vertical mount with the
screws supplied (➄ in
Installation on Platform
1. Place the separatory funnel clamp assembly on the platform.
2. Align the mounting bores with the platform.
3. Fasten the separatory funnel clamp assembly to the platform using the
screws supplied with the separatory funnel clamp (➅ in
Figure 92).
Accessories
side by side.
A
B
Figure 90.
Figure 91).
105 / 143
with its vertical
A
Funnel Clamp
A
Vertical Stand
B
➀ Smooth Bores for
Mounting to Platform
➁ Threaded Bores for
Mounting Funnel Clamp
➂ Standard Vertical Stand
Mounting Bores
➃ Upside Down Vertical
Stand Mounting Bores
➄ Screws with red thread
locker
➅ Screws without thread
locker
Figure
Figure 91) to install
Figure 91)
Figure 91
to
and