Table of Contents
Advertisement
3. 3. 5. Adjustable Angle Test Tube Rack Holder
Installation
CAUTION Cutting injuries from sharp edges. Be cautious while handling platforms
and other accessories.
Test tube rack holders and test tube racks are available in various sizes, as
listed in the chapter
page
29. All test tube rack holders are adjustable into seven positions,
swinging from 0° in either direction and locking at 15°, 30° and 45°.
Always use the screws supplied with the rack holder.
Figure 85: Adjustable Angle Test Tube Rack Holder with Test Tube Rack
Installed
Install as follows:
1.
Install the rack holders ➀ on the shaker platform using the screws
supplied.
2.
Slightly spread the metal tabs ➂ on either end of the rack holder's swing
bed ➅ and insert the test tube rack ➁.
3.
Secure the test tube rack ➁ by carefully releasing the tabs ➂.
4.
Pull the knobs ➄ of the locking pins on either end of the holder outward.
The pins are unlocked by turning the knob 1/4-turn.
5.
Rotate the swing-bed ➅ of the rack holder ➀ to the desired angle of 15°,
30° or 45° degrees.
6.
Reinstall the locking pin ➄ in the locating hole ➃ and lock the pin by
turning the knob 1/4-turn.
7.
To remove the rack, spread the metal tabs ➂ on either end of the swing
bed ➅ and lift out the test tube rack ➀.
Accessories
"1. 2. 5. Adjustable Angle Test Tube Rack Holders" on
99 / 143
➀ Rack holder
➁ Test tube rack
➂ Clamping tabs
➃ Locating bores
➄ Locking pin knob
➅ Swing bed of
holder
Advertisement
Table of Contents
