Thermo Scientific Solaris Series Instruction Manual page 98

Square Clamp Details
Each square clamp consists of a bottom panel with mounting bores and four
spring-loaded clip legs. Also included are screws for mounting the clamp on
the platform. Only use the screws supplied with the clamp.
➀ Mounting Bores ➁ Spring ➂ Clip Leg ➃ Screws
Figure 82: Square Clamp Details
Install as follows:
1. If needed, hook all springs ➁ into the clip legs ➂, as shown in
2. Place the clip assembly on the platform and align the mounting bores ➀.
3. Attach the clip assembly to the platform using the screws ➃ supplied.
4. Insert the square vessel from above.
5. Verify that the vessel rests on the bottom panel and is firmly seated in
the clamp.
Accessories
97 / 143
Figure 82.