Inspection Of Accessories; 4� 2� Cleaning; Touchscreen - Thermo Scientific Solaris Series Instruction Manual

Inspection of Accessories

NOTICE Do not run any shaker or accessories with signs of damage. It is
recommend that you have accessories inspected on a regular basis as part of your
routine service to ensure safety.
After thoroughly cleaning the accessories, they must be inspected for
damage, wear and corrosion.
Metal Parts
In case of damage, such as corrosion, wear or cracks, the accessories must
be removed from service immediately.
Plastic Parts
Check for signs of crazing, fading, bruising or cracking. In case of damage
the inspected item must be removed from service immediately.
Adhesive Mats
Before each use, inspect the adhesive mats for signs of wear or damage
including crazing, discoloration, yellowing, brittleness, deformation, surface
abrasions or chemical attack. Immediately discard adhesive mats showing
any signs of wear or damage.
4. 2. Cleaning
NOTICE Before using any cleaning methods, users should check with the
manufacturer of the cleaning agents that the proposed method will not damage
the equipment.
NOTICE The mechanism can be damaged by entering liquids. Do not allow liquids,
especially organic solvents, to get on the mechanism or the mechanism bearing.
Organic solvents break down the grease in the mechanisms bearing. Wash the
exterior of the unit with a soft cloth using a solution of mild soap and water, rinse off
with clean water and dry thoroughly.
Refer to "Basics" on page 124
used accessories.
NOTICE On temperature controlled shakers, make sure you leave the hood open
so cleaning agents and water can evaporate.

Touchscreen

To clean the touchscreen:
1. Pull out the power supply plug.
2. Clean the touchscreen using a dry microfiber cloth.
Cleaning
for proper cleaning of the shaker and the
125 / 143