2.
Choose Timed.
Figure 32: Select Time Mode
3.
Enter the hours and minutes in the Set Time boxes.
4.
Tap Save.
To return to the main screen, acknowledge the Your Settings have
5.
been saved confirmation dialog that appears.
Set Temperature
On temperature controlled models, the Temp Setpoint field allows you to
set a temperature for your application at any time.
1.
Tap anywhere on the Temp Setpoint field (bottom section of item ➅ in
Figure 27)
to open the Temp Setpoint screen shown in
2.
Tap the arrows above or below each dial of the wheel picker to
pre-set the default temperature you wish the shaker to maintain.
Alternatively, you can change the desired temperature by rotating each
dial of the wheel picker independently.
Figure 33: Set Temp Setpoint: Screen with Calibration Readout
Tap Save.
3.
NOTICE If a pop up screen appears informing you that the temperature
setpoint is out of range, your setting is outside of the shaker's supported range
of operating temperatures, as specified in the chapter
12. Correct your setting and continue.
Graphical User Interface
65 / 143
Figure
33.
"Technical Data" on page