Table of Contents
Advertisement
Section 1
Installation
Install the Flask Clips
Install the Test Tube
1-6
Orbital Shaker
The SHKE420HP will accommodate glassware in numbers and sizes from
forty-nine 25 ml flasks to six, 2-liter flasks.
Flask clips can be attached anywhere on the shaker platform. The
counterbalanced design of these shakers accommodates even an unbalanced
load. The flask clips are supplied with the proper screws and are attached
to the platform with a standard Phillips screwdriver or with the screwdriver
provided with the unit.
Table 1-1. Platform Flask Clip Capacity
Platform Number
238010
238011
238012
238013
238014
238015
238016
Figures 1-11 and 1-12 illustrate the installation of the flask clips. Note that
1-liter and 2-liter flask clips use five screws. The 250/300-flask clip has an
adhesive-backed flask cushion pad that is installed on the flat base of the
clip body. A hole is provided in the pad for the mounting screw. Refer to
Figure 1-11.
Accessory Test Tube Racks and Test Tube Rack Holders are available in
four sizes and are listed in Table 1-2. All the Test Tube Rack Holders are
Holders
adjustable into seven positions, swinging and locking at 15°, 30° and 45° in
either direction. Figure 1-13 illustrates the Test Tube Rack Holder with
rack in place.
Figure 1-13. Holder with Rack
No. of Clips
Flask Size
49
25 ml
49
50 ml
25
125 ml
18
250/300 ml
16
500 ml
8
1 L
5
2 L
Spread metal tabs outward
to remove test tube rack
. .. . .
. .
. .
. .. . .
. . .
.
. .
. .
. . .
. .. . .
. .. . .
.
. .
. .
. .
. .. . .
. .
. . .
. .. . .
. . .
.
. .
.
. .
. .
. .
.
. . .
. . .
.
Locking Pin to swing/tilt
test tube rack 15°, 30°, 45°
Springs/Clip
Screws/Clip
1
1
1
1
1
1
1 (w/1 lg. pad)
1
1
1
1
5
2 (w/10 tubes)
5
Thermo Scientific
Advertisement
Table of Contents
