Turning On The Device - Thermo Scientific Vanquish VH-D10 Operating Manual

5.9

Turning On the Device

Diode Array Detectors (VH-D10)
Operating Manual
TIP
Before turning on the power to a Vanquish system module for the first
time, verify that the chromatography software is installed on the data
system computer. When the power is turned on, the required USB
drivers are automatically found and the Windows™ operating system
can detect the device.
To turn on the power to the device, follow these steps:
1. Check that the power button on the front left of the Vanquish
system base (system power button) is pressed in. If the power
button stands out, press the power button to turn on the power on
the system base.
2. Turn on the device with its main power switch.
Turn off the device with the main power switch, when instructed to do
so, for example, during maintenance. Pressing the system power button
will not be sufficient to turn off the power to the device completely.
See also
2
Power On/Off Control (} page 89)
5 • Installation
Page 81