Thermo Scientific Vanquish VH-D10 Operating Manual page 61

Tubing Brackets
Dual System Arrangements
Diode Array Detectors (VH-D10)
Operating Manual
Each guide can hold up to three tubes or lines. In each module, push the
tube (or line) into the appropriate guide.
Figure 15: Tubing chase with tubing guides (left: view from inside, right:
view from top)
No. Use for
1 Solvent tubing (up to three solvent lines)
2 Solvent tubing (up to three solvent lines)
3 Wash liquid tubing (seal wash, autosampler needle wash)
4 Detector waste line
Tubing brackets are available for holding the tubing in place. Slip the
bracket side onto the drain pipe.
Figure 16: Tubing bracket (left), tubing bracket installed (right)
The number of tubes may exceed the capacity that the tubing guides can
hold. In this case, it is recommended to place the solvent lines in the
tubing guides and route any additional tubes freely in the tubing chase.
5 • Installation
Page 61