Turning On The Device - Thermo Scientific VF-F20-A Operating Manual

5.10 Turning On the Device

Integral Fraction Collector FT (VF-F20-A) Operating Manual
NOTICE
The shipping locks must be properly unpacked before you turn on the
device to avoid damage to the device.
TIP Before turning on the power to a Vanquish system module for the
first time, verify that the chromatography software is installed on the
data system computer. When the power is turned on, the required USB
drivers are automatically found and the Windows® operating system can
detect the device.
To turn on the power to the device, follow these steps:
1. Check that the power button on the front left of the Vanquish
system base (system power button) is pressed in. If the power
button stands out, press the power button to turn on the power on
the system base.
2. Turn on the device with its main power switch.
Turn the device off with the main power switch, when instructed to do
so, for example, during maintenance. Pressing the system power button
will not be sufficient to turn off the power to the device completely.
For power on/off control during device operation, see
Control ( page 104).
•
5 Installation
Power On/Off
Page 93