Shipping The Device - Thermo Scientific Vanquish VH-D10 Operating Manual

7.13.3 Shipping the Device

Preparations
Follow these steps
Restarting the Device after Shipping
Diode Array Detectors (VH-D10)
Operating Manual
4. Set up the device:
a) Connect the device and set up flow connections (see
(} page 45)).
b) Prepare the device for operation (see
Operation (} page 90)).
5. Before starting an analysis, let the device equilibrate and be sure
that it is ready for operation.
Prepare the device for transport. See
(} page 153).
CAUTION—Possible Contamination
Hazardous substances may have contaminated the device during
operation and may cause personal injury to service personnel.
• Decontaminate all parts of the device that you want to return for
repair.
• Fill in and sign the Health and Safety Form. Thermo Fisher Scientific
refuses to accept devices for repair if the Health and Safety Form is
missing, incompletely filled in, or unsigned.
1. Follow the unpacking instructions in this manual in the reverse
order.
Use only the original packing material and shipping container. If the
original shipping container is not available, appropriate containers
and packing material can be ordered from the Thermo Fisher
Scientific sales organization.
2. If you need to return the device to Thermo Fisher Scientific for depot
repair, contact your local Thermo Fisher Scientific support
organization for the appropriate procedure.
To install the device after shipping, follow the instructions on mounting
the system stack in the Vanquish System Operating Manual.
7 • Maintenance and Service
Preparing the Device for
Preparing the Device for Transport
Installation
Page 155