Replacing The Slide-In Module; Removing The Slide-In Module - Thermo Scientific Vanquish VH-D10 Operating Manual

7 • Maintenance and Service

7.14 Replacing the Slide-In Module

7.14.1 Removing the Slide-In Module

Tools required
Preparations
Follow these steps
Page 156
You can remove the slide-in module from the enclosure of a module for
transporting or shipping purposes. The enclosure remains in the system
stack. To return a defective module to the factory, install the slide-in
module in the enclosure of the replacement module.
CAUTION—Heavy Load, Bulky Device
The device is too heavy or bulky for one person alone to handle safely.
To avoid personal injury or damage to the device, observe the following
guidelines:
• Physical handling of the device, including lifting or moving, requires
a team effort of two persons.
• A team effort is in particular required when lifting the device into
the system stack or when removing it.
Screwdriver, Torx T20
1. Prepare the device for transport. See
Device (} page 153).
1. Loosen the four captive screws on the front left and front right of
the device.
Figure 45: Captive screws on the slide-in module (doors not shown)
Transporting or Shipping the
Diode Array Detectors (VH-D10)
Operating Manual