7
•
Maintenance and Service
Page 146
3. Remove the waste line from the top recess of the partition panel:
If the waste line is installed in a rotating plug
¨
Turn the plug in the top recess to the front and remove the
waste line from it.
If the waste line is installed in a plug with slit
¨
Pull the waste line out of the slit.
4. Remove the waste line from the device waste port in the system
base and from waste.
5. Unpack the replacement waste line.
6. Set up the waste line.
See also
2
Flow Connections to the Flow Cell (} page 66)
Diode Array Detectors (VH-D10)
Operating Manual