Trailing Arm Removal / Installation - Polaris RZR XP Service Manual

STEERING / SUSPENSION

TRAILING ARM REMOVAL / INSTALLATION

Use new attaching nuts upon installation of the rear
trailing arm and bearing carrier.
1. Raise and support vehicle by main frame.
WARNING
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure.
2. Remove the four wheel nuts and remove the rear
wheel.
3. Remove the cotter pin
w
hub castle nut . Remove the nut, cone washer
from the rear wheel hub assembly.
4. Remove the lower radius rod mounting bolt
and washer from the bearing carrier. Swing radius rod
down. Discard the nut.
8.28
NOTE
q
and loosen the rear wheel
5. Remove the two brake caliper mounting bolts
Discard bolts.
e
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.
6. Remove the rear wheel hub and brake disk assembly.
7. Remove the five remaining bolts
rear bearing carrier to trailing arm. Discard the nuts.
r
, nut
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
CAUTION
y
that attach the
© Copyright Polaris Industries Inc.
t
.