Rear Bearing Replacement - Polaris RZR PRO XP 2020 Service Manual

FINAL DRIVE

REAR BEARING REPLACEMENT

Bearing Removal
1. Remove the outer snap ring
2. From the back side of the bearing carrier, tap on the
outer bearing race with a drift punch in the reliefs as
shown.
3. Drive bearing out evenly by tapping on outer race
only. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
4. Inspect the bearing carrier housing for scratches,
wear or damage. Replace rear bearing carrier if
damaged.
Bearing Installation
5. Thoroughly clean the rear bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
8.8
q
.
7. Apply Loctite ® 603
outer circumference of the new bearing race
carefully press the new bearing into the bearing
e
carrier housing .
NOTICE
Use care to not allow any of the Loctite
get in the bearing.
8. Wipe the housing clean of any excess compound
and install the snap ring
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
™ retaining compound to the
® compound to
r
.
© Copyright Polaris Industries Inc.
w
and