Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node
Replacing the Node
Obtaining a
Replacement Node
172
7 Verify that the following iDRAC setting is set to Disabled:
• Enable IPMI Over LAN - Disabled
8 Press <ESC> twice.
The system prompts you to save the changes.
9 Select Yes and press <Enter>.
The system states that the changes were saved.
10 Select OK and press <Enter>.
11 Select Yes and press <Enter> to reboot the system.
This section describes how to remove and replace the DXi6900 G1 Node
and contains the following sections:
•
Obtaining a Replacement Node
•
Replacing the Node
Before beginning the replacement procedure, make sure that you have
the required replacement kit. The appropriate replacement Node will be
provided by Quantum Customer Support (see
You will need the following items to perform this procedure:
• Replacement Node kit provided by Quantum Customer Support.
• Masking tape and felt tip marker (for temporarily labeling hard
drives)
• ESD grounding wrist strap (included in the replacement kit)
Figure
103).
Quantum DXi6900 G1 User's Guide