Replacing The Bezel - Quantum Scalar i40 Replacement Manual

Quantum Scalar i40 and Scalar i80: Bezel Replacement
6-66553-03 Rev B
February 2014
Figure 3 Scalar i80 Pull/Push
Locations

Replacing the Bezel

6
Pull in this area
when removing
bezel. Push in
this area when
installing bezel.
These instructions explain how to replace the bezel on the library:
1 Install the new bezel straight onto the library:
Do not tip or twist the bezel. Be careful not to scratch or damage the bezel
as you install it.
a Slide the top and bottom edges of the bezel to the inside of the top and
bottom layers of the chassis sheet metal.
b On the Scalar i80, press in near the center on both sides of the bezel
until you hear it "snap" into place (see
Caution: Make sure the power button and all four Operator panel
control buttons appear through the holes in the bezel and are
not trapped beneath the bezel.
2 Install the two top screws, then the two bottom screws.
3 Reinstall the library in the rack or desktop kit.
4 Reinstall all drives that were removed from the library.
5 Insert all magazines back into their original positions in the library.
6 Turn the library ON by pressing the power button on the front panel and
wait until the library initializes before resuming library operations.
7 If you removed the library from the rack to perform this procedure, run the
Installation and Verification Test (IVT) to ensure that the robot (Y-tray), tape
drives, and magazines are all functioning properly:
a From the Operator panel, select Tools > IVT.
b Follow the instructions on the screen.
The IVT takes about 30 minutes to complete.
Pull in this area
when removing
bezel. Push in
this area when
installing bezel.
Figure 3 for locations).
Replacing the Bezel