Removing and
Installing the Cable
Retention Bracket
Figure 144 Removing and
Installing the Cable Retention
Bracket
Quantum DXi6900 G1 User's Guide
To remove and replace the cable retention bracket, refer to the
following procedures:
•
Removing the Cable Retention Bracket
•
Replacing the Cable Retention Bracket
Removing the Cable Retention Bracket
To remove the cable retention bracket:
1 Remove all cables routed through the cable retention bracket (see
Figure
144).
2 Press the tab and slide the cable retention bracket toward the front
of the chassis to release it from the chassis.
3 Lift the cable retention bracket out of the chassis.
Alignment pins
Replacing the Cable Retention Bracket
To replace the cable retention bracket:
1 Using alignment pins as guide, slide the cable retention bracket
along the chassis wall until the tab snaps into place (see
Figure
144).
Chapter 3: FRU Removal and Replacement Procedures
Additional Removal and Replacement Procedures
Tab
Cable retention bracket
227