Quantum DXi6900 Field Service Manual page 197

Quantum DXi6900 G1 User's Guide
11 Verify that the service tag number was successfully written using the
Service Menu:
a Access the Service Menu (see
Menu on page 38).
b Navigate to Serial Numbers > Display Node Serial Number.
Updating the OEM ID
To update the OEM ID:
1 Connect to the system node via the iDRAC port and launch the
Virtual Console Viewer (see
the iDRAC Port on page 34).
2 In the left pane of the iDRAC main console, click Overview > iDRAC
Settings > iDRAC Firmware Update.
3 Upload the 82DFV_R720_CustBSU.pm file.
Wait for the iDRAC reboot to complete.
4 Reboot the system.
Wait for the system to complete one more self reboot before the
updated BIOS splash logo displays.
Verifying iDRAC Settings
After replacing the system board, you must verify that certain iDRAC
settings are set to the Quantum required value, and make any changes
as needed:
1 As the system boots, press F2 to display the System Setup Main
Menu.
2 Select iDRAC Settings and press <Enter>.
3 Select LifeCycle Controller and press <Enter>.
4 Verify that the following two iDRAC settings are set to Enabled:
• LifeCycle Controller - Enabled
• Collect System Inventory On Restart - Enabled
5 Press <ESC> to return to the iDRAC Settings Menu.
6 Select Network and press <Enter>.
Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node System Board
Accessing the DXi6900 G1 Service
Connecting to the System Node Using
171