Figure 99 Hard Drive Backplane Cabling Diagram - Quantum DXi6900 Field Service Manual

Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Hard Drive Backplane
Figure 99 Hard Drive
Backplane Cabling Diagram
Integrated storage
controller card
System board
Cable retention bracket
162
Installing a Replacement Hard Drive Backplane
To install the replacement hard drive backplane in the DXi6900 G1
Node:
1 Use the hooks at the base of the chassis as guides to align the hard
drive backplane (see
2 Slide down the hard-drive backplane until the release tabs snap into
place.
3 Connect the SAS data, signal, and power cables to the backplane.
4 Replace the cooling fan assembly (see
Cooling Fan Assembly
5 Install the hard drives in their original locations (see
Node Hard Drive
SAS SAS
B A
Figure 98 and Figure
on page 224).
on page 90).
Quantum DXi6900 G1 User's Guide
SAS connector on
system board
SAS connector on
system board
99).
Removing and Installing the
Replacing a