Figure 129 Removing And Installing An Array Module Controller - Quantum DXi6900 Field Service Manual

Chapter 3: FRU Removal and Replacement Procedures
Replacing an Array Module Controller
Figure 129 Removing and
Installing an Array Module
Controller
Array module controller handles
206
4 Insert the controller air blocker into the open controller slot to make
sure that correct airflow is maintained.
Installing a Replacement Array Module Controller
To install the replacement Array module controller:
1 Remove the BBU from the failed Array module controller and install
the BBU in the replacement controller (see
Module BBU on page 208).
2 Remove the controller air blocker from the controller slot.
3 Slide the replacement Array module controller into the empty bay
until the controller snaps into place, and push the handles into the
closed position (see
4 Connect the SAS cables to the new controller (see
on page 241):
5 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see
Figure 129).
Factory Detect Hardware
Quantum DXi6900 G1 User's Guide
Replacing an Array
Cabling Diagrams
on page 44).