Figure 88 Removing and
Installing the Integrated
Storage Controller Battery
Replacing the Node Network Daughter Card
Quantum DXi6900 G1 User's Guide
Installing a Replacement Integrated Storage Controller
Battery
To install the replacement integrated storage controller battery in the
DXi6900 G1 Node:
1 Plug the replacement battery cable into the integrated storage
controller and insert the battery into the controller (see
2 Replace the integrated storage controller (see
Integrated Storage
3 Close the Node cover (see
4 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see
5 In the remote management console, delete any administrative alerts
and close any service tickets.
This section describes how to remove and replace the network daughter
card in the DXi6900 G1 Node and contains the following sections:
•
Obtaining a Replacement Network Daughter Card
Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Network Daughter Card
Controller).
Opening and Closing the
Factory Detect Hardware
Storage controller
battery
Figure
88).
Replacing the
Node).
on page 44).
147