Figure 102 Removing And Installing The System Board - Quantum DXi6900 Field Service Manual

Figure 102 Removing and
Installing the System Board
System board holder
System board
Quantum DXi6900 G1 User's Guide
8 Remove the heatsinks and processors (see
and Heatsink on page 153).
WARNING: The heatsink and processor are hot to the touch for
some time after the system has been powered down.
Allow the heatsink and processor to cool before
handling them.
9 Remove the memory modules (see
Module on page 103).
10 Remove the network daughter card. (see
Daughter Card on page 148).
Installing a Replacement System Board
To install the replacement system board in the DXi6900 G1 Node:
1 Transfer the following components to the new system board:
Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node System Board
Release pin
Support bracket (not present
on all systems)
Replacing a Node Memory
Replacing the Processor
Replacing the Network
167