Figure 106 Removing And Installing The Mini Sas Cable Connector - Quantum DXi6900 Field Service Manual

Figure 106 Removing and
Installing the Mini SAS Cable
Connector
Quantum DXi6900 G1 User's Guide
a Push the mini SAS cable connector to slide it further into the
connector (J_SASX8) on the system board (see
b Press down and hold the metal tab on the mini SAS cable
connector.
c Pull the mini SAS cable out of the connector on the system
board.
Metal tab
Mini SAS cable
connector
6 Disconnect all cables from the system board.
7 Grasp the system board holder, lift the blue release pin, and slide
the system board toward the front of the system (see
Caution: Take care not to damage the system identification
button while removing the system board from the
chassis.
Caution: Do not lift the system board assembly by grasping a
memory module, processor, or other components.
Note: Leave the CPUs and heatsinks, memory modules, and
network daughter card installed in the system board. There
is no need to remove these components.
Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Chassis
Figure 106).
Connector on the
system board
Figure 107).
179