Figure 63 Removing And Installing A Cmos Battery - Quantum DXi6900 Field Service Manual

Figure 63 Removing and
Installing a CMOS Battery
Quantum DXi6900 G1 User's Guide
5 Lift the battery out of the securing tabs at the negative side of the
connector.
Installing a Replacement CMOS Battery in the Node
To install the replacement CMOS battery in the DXi6900 G1 Node:
1 Support the battery connector by pressing down firmly on the
positive side of the connector.
2 Hold the battery with the "+" facing up and slide it under the
securing tabs at the positive side of the connector.
3 Close the Node cover (see
page 78).
4 Turn on the system (see
on page 21).
5 Log on to the remote management console as the service user (see
Accessing Remote Management
6 Navigate to the Status > Hardware > Summary > System Board
Details page to confirm that the battery is operating properly.
7 Verify that the BIOS settings are set correctly (see
G1 BIOS Settings
8 Navigate to the Configuration > System > Date & Time page to
enter the correct time and date.
Chapter 3: FRU Removal and Replacement Procedures
Opening and Closing the Node
Turning On and Shutting Down the System
on page 23).
on page 234).
Replacing Node CMOS Battery
on
Required DXi6900
113