Quantum DXi6900 Field Service Manual page 207

Quantum DXi6900 G1 User's Guide
Caution: Take care not to damage the system identification
button while placing the system board into the chassis.
3 Push the system board toward the back of the chassis until the
board clicks into place.
4 Install the following components (removed form the failed Node
chassis) in the replacement Node chassis:
a Hard drive backplane (see
on page 160).
b Information tag (see
Tag on page 228).
c Cable retention bracket (see
Retention Bracket
d PCIe card holder (see
Holder on page 226).
e Integrated storage controller card (see
Storage Controller
f Expansion card risers (see
1 on page 118 and
on page 122).
g Cooling fan assembly (see
Fan Assembly
h Power supplies (see
page 95).
5 Reconnect all cables to the system board.
Note: If using optical 10 GbE cables, move the SFPs from the
failed Node chassis to the replacement Node chassis.
Note: Ensure that the cables inside the system are routed along
the chassis wall and secured using the cable securing
bracket.
6 Close the Node cover (see
Chapter 3: FRU Removal and Replacement Procedures
Replacing the Hard Drive Backplane
Removing and Installing the Information
Removing and Installing the Cable
on page 227).
Removing and Installing the PCIe Card
on page 136).
Replacing an Expansion Card in Riser
Replacing an Expansion Card in Riser 2 or 3
Removing and Installing the Cooling
on page 224).
Replacing a Node Power Supply
Opening and Closing the
Replacing the Node Chassis
Replacing the Integrated
on
Node).
181