Figure 67 Removing and
Installing an Expansion Card in
Riser 1
Quantum DXi6900 G1 User's Guide
Expansion card connector
Riser 1 cage
A
Installing an Expansion Card in Riser 1
To install a replacement expansion card in riser 1:
1 Holding the card by its edges, position the card so that the card
edge connector aligns with the expansion card connector (see
Figure
67).
2 Insert the card edge connector firmly into the expansion card
connector until the card is fully seated.
3 Close the expansion card latches.
4 If applicable, connect any cables to the expansion card.
5 Install the expansion card riser (see
6 Close the Node cover (see
7 Turn on the system (see
on page 23).
8 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see
Chapter 3: FRU Removal and Replacement Procedures
Replacing Node Expansion Cards
B
Figure
Opening and Closing the
Turning On and Shutting Down the System
Factory Detect Hardware
Expansion card
66).
Node).
on page 44).
121