Installing A Replacement Drive In An Array Or Expansion Module; Figure 120 Removing And Installing An Array Or Expansion Hard Drive - Quantum DXi6900 Field Service Manual

Chapter 3: FRU Removal and Replacement Procedures
Replacing Array or Expansion Module Hard Drives
Figure 120 Removing and
Installing an Array or
Expansion Hard Drive
Installing a
Replacement Drive in
an Array or Expansion
Module
196
Hard drive handle
To install the replacement hard drive in a DXi6900 G1 Array module
(RBOD) or Expansion module (EBOD):
Caution: When installing a hard drive, ensure that the adjacent
drives are fully installed. Inserting a hard-drive carrier and
attempting to lock its handle next to a partially installed
carrier can damage the partially installed carrier's shield
spring and make it unusable.
1 Open the hard-drive carrier handle (see
2 Insert the hard-drive carrier into the hard-drive slot until the carrier
connects with the backplane.
3 Close the hard-drive carrier handle to lock the hard drive in place.
• It may take up to 30 seconds for the system to detect that a
failed drive was removed and a new drive was inserted.
• The activity indicator for all drives in the Array module or
Expansion module will blink green while the drive is rebuilding.
Hard drive carrier
Figure
Quantum DXi6900 G1 User's Guide
120)..