Quantum DXi6900 G1 User's Guide
3 Remove the following components:
a Power supplies (see
page 95).
b Cooling fan assembly (see
Fan Assembly
c Expansion card risers (see
1
on page 118 and
on page 122).
d Integrated storage controller card (see
Storage Controller
e PCIe card holder (see
Holder
on page 226).
f Cable retention bracket (see
Retention Bracket
g If present, support bracket (see
Note: The support bracket is present on certain system
configurations for protection during shipping and can
be discarded after removal.
4 Disconnect the mini SAS cable from the system board:
Caution: To avoid damaging the mini SAS cable and connector,
follow the correct procedure when removing the mini
SAS cable from the system board.
a Push the mini SAS cable connector to slide it further into the
connector (J_SASX8) on the system board (see
b Press down and hold the metal tab on the mini SAS cable
connector.
c Pull the mini SAS cable out of the connector on the system
board.
Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node System Board
Replacing a Node Power Supply
Removing and Installing the Cooling
on page 224).
Replacing an Expansion Card in Riser
Replacing an Expansion Card in Riser 2 or 3
on page 136).
Removing and Installing the PCIe Card
Removing and Installing the Cable
on page 227).
Figure
on
Replacing the Integrated
102).
Figure
101).
165