Configuring the
Number of Traditional
and OST Replication
Streams
Quantum DXi6900 G1 User's Guide
Note: To change the number of traditional and OST replication
streams, a reboot of the target system is necessary.
Configuring the number of allowed sources and replication streams
consists of the following steps:
•
Configuring Traditional Replication Streams
•
Configuring OST Replication Streams
Configuring Traditional Replication Streams
To change the number of traditional replication streams used, you must
perform the following steps on each source system.
1 Connect to the DXi6900 G1 Node (see
G1 Node
on page 32).
2 Edit the ObjectManager.conf file (using VI editor) in the /data/
hurricane/conf directory.
3 In the ObjectManager.conf file, change the variable
<MaxReplicationStreams> to the new value.
4 Reboot the source system using the Utilities > Reboot &
Shutdown page in the remote management console.
Configuring OST Replication Streams
To change the number of OST replication streams used, you must
perform the following steps on each source system.
1 Connect to the DXi6900 G1 Node (see
G1 Node
on page 32).
2 Edit the ObjectManager.conf file (using VI editor) in the /data/
hurricane/conf directory.
3 In the ObjectManager.conf file, change the variable <Max number
of Replication Streams for OST Replication> to the new value.
4 Reboot the source system using the Utilities > Reboot &
Shutdown page in the remote management console.
Configuring the Number of OST Replication Streams
Connecting to the DXi6900
Connecting to the DXi6900
Chapter 2: Service Menus
63