Figure 139 Removing And Installing An Expansion Module Esm Canister - Quantum DXi6900 Field Service Manual

Chapter 3: FRU Removal and Replacement Procedures
Replacing an Expansion Module ESM Canister
Figure 139 Removing and
Installing an Expansion Module
ESM Canister
Expansion Module controller handles
218
Installing a Replacement Expansion Module ESM
To install the replacement Expansion module ESM canister:
1 Slide the replacement Expansion module ESM canister into the
empty bay until the canister snaps into place, and push the handles
into the closed position (see
2 Connect the SAS cables to the new ESM canister (see
Diagrams on page 241):
3 Update the ESM canister firmware:
a Access the Service Menu (see
Menu on page 38).
b Navigate to Hardware Configuration > Setup external
Storage > Upgrade Array Firmware > Upgrade ESM (EBOD)
firmware.
c Follow the prompts to update the ESM firmware. Make sure to
specify the correct Array module and Expansion module.
Figure 139).
Accessing the DXi6900 G1 Service
Quantum DXi6900 G1 User's Guide
Cabling