Parking Brake Cable Removal And Installation; Specifications; Tightening Torque Specifications - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:

Table of Contents

4D-4 Parking Brake:

Parking Brake Cable Removal and Installation

When it is necessary to remove both right

and left parking brake cables, repeat the

following steps 4) to 6) on right and left

1) Hoist vehicle.

2) Remove wheel.

3) Disconnect parking brake cable from equalizer

(parking brake lever) and clamps.

4) Remove brake drum. Refer to "Rear Brake Drum

Removal and Installation in Section 4C".

Fastening part

Parking brake lever bolt

The specified tightening torque is also described in the following.

"Parking Brake Cable Location"

For the tightening torque of fastener not specified in this section, refer to "Fastener Information in Section 0A".

5) Disconnect parking brake cable from brake shoe

S6JB0A4406003

lever referring to "Rear Brake Shoe Removal and

Installation in Section 4C".

6) Remove parking brake cable and parking cable

Installation

Install it by reversing removal procedure, noting the

following points.

• Install clamps properly referring to "Parking Brake

Cable Location".

• Tighten bolts and nuts to specified torque referring to

"Parking Brake Cable Location".

• Adjust parking brake cable. Refer to "Parking Brake

Check and Adjustment".

• Check brake drum for dragging and brake system for

proper performance. Brake test should be performed.

Tightening torque

S6JB0A4407001

Table of Contents