Crankshaft Position (Ckp) Sensor Removal And Installation - Suzuki 2006 SX4 Service Manual

1C-10 Engine Electrical Devices:
Performance check
1) Remove metal particles on end face of CMP sensor,
if any.
2) Arrange 12 V battery (1) and connect its positive
terminal to "Vin" terminal (2) and negative terminal to
"Ground" terminal (3) of sensor. Then using
ohmmeter, measure resistance between "Vout"
terminal (4) of sensor and negative terminal of
battery by passing magnetic substance (iron) (5)
while keeping approximately 1 mm (0.03 in.) gap
with respect to end face of CMP sensor.
If resistance does not vary as specified below,
replace CMP sensor.
CMP sensor resistance
Resistance varies from less than 220 Ω (ON) to
infinity (OFF) or from infinity (OFF) to less than 220
Ω (ON)
[A]: Non-VVT model
I4RS0B130016-02
[B]: VVT model
Crankshaft Position (CKP) Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Remove generator drive belt, loosen pivot bolt and
move generator rearward.
3) Disconnect connector from crankshaft position
sensor.
4) Remove crankshaft position sensor (1) from cylinder
block.
Installation
1) Install crankshaft position sensor to cylinder block.
Tighten CKP sensor bolt to specified torque.
Tightening torque
CKP sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
2) Connect connector to CKP sensor securely.
3) Adjust generator drive belt tension referring to
"Water Pump / Generator Drive Belt Tension
Inspection and Adjustment in Section 1F".
4) Connect negative cable to battery.
S6RW0D1306014
I2RH0B130012-01
(a)
I4RS0A130007-01