Out Bin Full - Xerox Phaser 3140 Service Manual

Out Bin Full

Phaser 3140/3155/3160 Printer Service Manual
The red Error LED is blinking.
Initial Actions
• Check the Out Bin Full Actuator for damage or obstructions.
• Cycle printer power.
• If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Top Cover, PL2.0
Controller Board, PL1.0.2
Out Bin Full Sensor, PL6.0.73
Troubleshooting Procedure Table
Step Actions and Questions
1 Remove the Top Cover (page 8-23),
and check the Output Bin Full
Actuator for damage.
Is the actuator damaged?
2 On the Controller Board check for
+3.3 V at CN2-1 (CN15-1 on printer
model 3160).
Is +3.3 V present?
3 Check the continuity of the bin full
harness connecting the Controller
Board and Out Bin Full Sensor.
Is the harness damaged?
Error Messages and Codes
Wiring and Plug/Jack Map References
3140 Controller Board Wiring
3155 Controller Board Wiring
3160 Controller Board Wiring
Map 1 - Controller Board (3140)
Map 2 - Controller Board (3155)
Map 3 - Controller Board (3160B/
3160N)
Map 5 - Sensors
Yes
Repair the
actuator if
possible, or
replace the Top
Cover
(page 8-23). If
the problem
persists, go to
step 2.
Go to step 3.
Repair the
harness.
No
Go to step 2.
Replace the
Controller
Board
(page 8-51). If
the problem
persists, go to
step 3.
Replace the
Out Bin Full
Sensor
(page 8-63).
3-17